 The Diamond 105 System has been a successful patented
system for the past 22 years with no failures and it also exceeds
all state voc laws.Architects,
engineers, contractors and building owners can be assured of a
quality installation with Diamond 105. IDS unique diamond pattern
fastening technique (forms 2’8” stress pattern) bonds with the lower
surface of the rubber membrane to form a secure, weather-tight,
non-penetrating surface.
The Diamond 105 (patented) System is
a 7” x 7” plate utilizing butyl tape technology. Plates are fastened
down through the insulation and deck in a diamond pattern. Apply
tape primer to the sheet where contact with the plates will occur.
Peel the release paper from the 105 plates and float the EPDM
membrane over the plates. (NOTE: This system was made possible by
IDS development of pre-cured tape in approximately 1987.)
The Diamond 75 System utilizes the
same pattern and technology as the 105 system but uses a 6” x 6”
plate. This makes it the perfect choice for residential and smaller
commercial applications. Whatever version you choose, rest assured
you are utilizing one of the worlds most innovative and time saving
systems to apply.
The proof in this system is in the
following: speed of application is due to ½ the plates and screws
compared to a fully adhered system, one fourth of the labor is
needed to install the plates compared to applying a fully adhered
system, and the material for the Diamond 105 System is less
expensive compared to the fully adhered system.
The Diamond 105 plate has just been
improved by pre-drilling the center of the plate eliminating the
possibility of butyl tape build up on your drill and making it
easier access to the steel plate. Warranties are available for up to
30 years.
|
